THROTTLE CABLE GUIDE ROLLER

Out of stock
BB-103

Bus's always suffered with the throttle cable cutting into the gearbox just after the cable comes out of the chassis section in front of the gearbox. VW originally fitted a floppy tube setup, only way around this problem prior to this kit was to modify a Beetle tube.
These tubes to create drag on the cable, so cable would stick.

This roller just bolts to the gearbox, kit comes with a new M8 nut and locking washer, you simply undo the nut and bolt this kit on, leaving it loose until the cable is threaded through, then set the best position for it to sit in and torque up the gearbox nut, that is it. Very easy if like us you do not run heat exchangers. Still doable with heat exchangers just a little less room to swing the spanner. Will fit stock or modified vehicles Swing.
Both the rollers have bearings inside and the body sections are plated in an anti corrosion plating.
Makes the cable run very free, and stops the cable sawing into the gearbox.
Most gearboxes have these cable scars. Its a fit and forget item.

Weight
0.0300
Part #
BB-103
A$35.75